×

+800 505 4900 Our lines are open:
Blockout

Blockout

(4)
    • - 44 %
    On backorder

    This product is a low viscosity, water soluble green block-out designed to fill the open areas of the screen not covered by the emulsion. Use for masking several designs on a screen until ready to print or for multi-color work.

    I   When the screen is dry and free of contaminants, pour Quik-Dry® on the print side of the screen. Spread over the open areas of the screen until completely filled.

    II  Touch up all defects, including heavy blobs which tend to dry on the outside and pop off or smear during printing. Where very fine meshes are used, you may reduce the viscosity by adding a little water.

    III Remove blockout with water.

    • In stock
      This product is a medium viscosity, water soluble red blockout designed to fill the open areas of the screen not covered by the emulsion.
      • - 89 %
      On backorder

      AQUA-BLOCK is a water-based, yet water resistant, violet block-out designed to fill the open areas of the screen not covered by the emulsion. Use for masking several designs on a screen until ready to print or for multi-color work. AQUA-BLOCK is very good for touching up pinholes.

      • - 51 %
      On backorder

      A heavy, non-flammable, water-soluble blockout with drying characteristics similar to Indirect Films.

      The high viscosity of Extra Heavy Blockout No. 10 affords easier handling, and generally assures effective coverage in a single coating. Especially useful with coarse mesh. Can be used for touchups when thinned with cold water. Can be used in unventilated rooms since it contains no organic solents. Recommended for use on all fabrics, with all stencil systems. Use only with non-aqueous inks.

    We are the right partner for you

    This is why